User bio
404 bio not found
Member since Dec 3, 2021
Posts:
Tim has not published any posts yet.
Replies:
show all 9
Tim Huggins · Feb 15, 2024 go to post

Look at the parameters you can pass to the use command - the below will do what you want

u $i:(:"+S")

read password

or  if doing directly at the command line instead of from a called routine

u $i:(:"+S") read password 

Tim Huggins · Dec 2, 2023 go to post

Check whether the tstart command is issued with a post conditional parameter   if so then you may be able to make the ts fail and therefore the ts would not start the transaction. 

For instace if you had:

Tstart:$g(^startts)=1

Then killing ^startts would cause the transaction not to be created.

#longshot

Certifications & Credly badges:
show all 1
Followers:
Tim has no followers yet.
Following:
Tim has not followed anybody yet.