User bio
404 bio not found
Member since Dec 15, 2015
Posts:
Fernando has not published any posts yet.
Replies:
show all 5
Fernando Telesca · May 20, 2019 go to post

Hi Rizmaan,

If you are using System Management Portal to run it, you need to select "ODBC Mode". 

Rgds

Fernando Telesca · Aug 25, 2016 go to post

Note that Dmitry's answer and mine are pretty much the same, except that I like to avoid post conditional commands where it´s not strictly needed  wink

Fernando Telesca · Aug 25, 2016 go to post

Hi Sebastian,

Set FF = ""
For {
 Set FF=$Order(^Users(FF))
 If FF="" Quit
 If $Get(^Users(FF,"SETTINGS","isAllowed"))=1 {
  Write !,"User ",FF," is allowed"
 }
}


Rgds

Certifications & Credly badges:
Fernando has no Certifications & Credly badges yet.
Followers:
Fernando has no followers yet.
Following:
Fernando has not followed anybody yet.